NEFF D96IKW1S0B Manual

Also see for D96IKW1S0B: User manual and installation instructions User manual and installation instructiions User manual and installation instructions User manual and installation instructions

Contents

NEFF D96IKW1S0B Manual Manual pdf 21 page image

Installation en21Wall-mounting the appliance and levelling it1. First remove the protective film from the back of theappliance and, following installation, remove the restof the film.2. When mounting the appliance, ensure that itengages properly with the mounting supports.3. If required, the appliance can be moved to the rightor to the left.4. Firmly tighten the screws for the mounting supports.Hold the bracket firmly when doing so. ¨5. If no duct is to be fitted, screw in the two lockingscrews without the bracket. ©Connecting the pipesIf the extractor hood is to be operated in exhaust-airmode, the pipes must be connected. If the extractorhood is to be operated in air-recirculation mode, anoptional accessory must be fitted. To do this, refer tothe installation instructions provided.Note: If an aluminium pipe is being used, smooth theconnection area beforehand.Exhaust air pipe, dia. 150 mm (recommended size)Fit the exhaust air pipe directly to the air-pipe connectorand seal the joint.Exhaust air pipe, dia. 120 mm1. Fit the reducing connector directly to the air-pipeconnector.2. Attach the exhaust air pipe to the reducingconnector.3. Use suitable means to seal both joints.Attaching the flue ductIf the extractor hood is to be operated in exhaust-airmode, a flue duct must be fitted.The flue duct does not need to be fitted for air-recirculation mode.:WarningRisk of injury!From sharp edges during installation. Always wearprotective gloves while installing the appliance.:WarningRisk of electric shock!Components inside the appliance may have sharpedges. These may damage the connecting cable. Donot kink or pinch the connecting cable duringinstallation.1. Separate the flue duct sections by removing theadhesive tape.2. Remove the pieces of protective film from both flueduct sections.3. Push one flue duct section into the other.Notes– To prevent scratches, lay paper over the edges ofthe outer flue duct section to protect the surface.– The slots of the inner flue duct section pointdownwards.4. Place flue ducts sections on the appliance.5. Slide the inner flue duct section upwards, attach it tothe left and right sides of the retaining bracket, andthen slide it down to engage it. ¨6. Screw the flue duct section to the sides of theretaining bracket using two screws. ©7. Clip the lower flue duct section in at the retainingbracket. The connection cable must not bedamaged. ªNote: If an air-recirculation optional accessory has beenfitted and the extractor hood is to be operated without aflue duct, the cable must be wound onto the connector.

/ 24

Related manuals for NEFF D96IKW1S0B