NEFF D96IKW1S0B Manual

Also see for D96IKW1S0B: User manual and installation instructions User manual and installation instructiions User manual and installation instructions User manual and installation instructions

Contents

NEFF D96IKW1S0B Manual Manual pdf 19 page image

Installation en195InstallationInstallation Preparing for installationCaution!Ensure that there are no electrical wires, gas pipes orwater pipes in the area where holes are to be drilled.If the extractor hood is to be operated in exhaust-airmode, a flue duct must be fitted.If the extractor hood is to be operated in air-recirculationmode, an optional accessory must be fitted. To do this,refer to the installation instructions provided. The flueduct does not need to be fitted for air-recirculationmode.1. Determine where the extractor hood should bepositioned and lightly mark where the lower edge ofthe appliance should be on the wall. Determinewhere the middle should be based on the hob.Note: We recommend fitting the extractor hood suchthat the lower edge of the glass screen is in line withthe lower edges of the adjacent wall-hung cabinets.Make sure that the specified safety clearances fromthe hob are complied with.2. Place the template against the line drawn on the walland fasten it in place. Mark where the screws shouldbe inserted.To fit the flue duct, the template must be cut alongthe marked cut line.3. Drill 8 mm diameter holes to a depth of 80 mm forfastening the appliance, remove the template andpress in the wall plugs flush with the wall.$%]][PP[PP[PP[PP\\