956. Using On-Screen Menu[INSTALLATION(2)][NETWORK SETTINGS]This feature allows you to set various setting items when the projector is used on your network.CAUTION• Consult with your network administrator about these settings.Hints on How to Set Up LAN ConnectionTo configure the projector to communicate on the network using the LAN port (RJ-45):1. Select the [WIRED] tab for the LAN port (RJ-45).2. On the [WIRED] tab, select a number from the [PROFILES] list for your LAN settings.Two settings can be stored in memory for the LAN port.3. On the [WIRED] tab, turn on or off [DHCP], specify IP address, Subnet Mask, Gateway and DNS Con-figuration. Select [OK] and press the ENTER button.(→ page 98)To recall the settings from memory:After selecting the [WIRED] tab, select the number from the [PROFILES] list.Select [OK] and press the ENTER button. (→ page 98)To connect a DHCP server:On the [WIRED] tab, select [DHCP] and press the ENTER button. A check mark will be placed. Select againand press the ENTER button. The check box will be cleared.When setting an IP address without using a DHCP server, clear the check box for [DHCP]. (→ page 98)
