NEC VT70 User Manual

Also see for VT47 Series: Control commands Command guide Command guide Control commands Specifications

Contents

NEC VT70 User Manual Manual pdf 31 page image

243. Projecting an Image (Basic Operation)Place your projector on a flat level surface and ensure that the projector issquare to the screen.Lift the front edge of the projector to center the image vertically.* If the projected image does not appear square to the screen then use theKeystone feature for proper adjustment. See page 26. Adjusting the Picture Size and PositionAC INZOOMFOCUSAC INZOOMFOCUSAdjust the Tilt Foot1. Lift the front edge of the projector.2. Push up the Adjustable Tilt Foot Levers on the right and left sidesof the projector to extend the adjustable tilt feet (maximum height).3. Push down the Adjustable Tilt Foot Levers.4. Lower the front of the projector to the desired height and releasethe Adjustable Tilt Foot Lever to lock the Adjustable tilt foot. Thereis approximately 10 degrees of up and down adjustment for thefront of the projector.CAUTIONDo not use the tilt-foot for purposes other than originally intended. Misusessuch as gripping the tilt-foot or hanging on the wall can cause damage to theprojector.2ZOOMFOCUSSELECTLAMPSTATUSPOWERVIDEOS-VIDEOCOMPUTER-1 COMPUTER-2ON/STAND BYAUTOADJ.12ZOOMFOCUSSELECTLAMPSTATUSPOWERVIDEOS-VIDEOCOMPUTER-1 COMPUTER-2ON/STAND BYAUTOADJ.344Adjustable Tilt FootMove the projector left to center the image horizontally on the screen.Adjustable TiltFoot LeverAdjustable TiltFoot Lever