NEC VT70 User Manual

Also see for VT47 Series: Control commands Command guide Command guide Control commands Specifications

Contents

NEC VT70 User Manual Manual pdf 13 page image

61. IntroductionTop FeaturesLAMPSTATUSPOWER VIDEOAUTOADJ.S-VIDEO COMPUTER-1 COMPUTER-2AUTOADJ.COMPUTERON/STAND BYSELECT12 1310 2 3 4111 5 6 778981. POWER Button (ON / STAND BY) ( )Use this button to turn the power on and off when themain power is supplied and the projector is in standbymode.To turn on the projector, press and hold this button fora minimum of two seconds. To turn off the projector,press this button twice.2. POWER IndicatorWhen this indicator is green, the projector is on; whenthis indicator is orange, it is in standby mode. See thePower Indicator section on page 53 for more details.3. STATUS IndicatorIf this light blinks red rapidly, it indicates that an errorhas occurred, the lamp cover is not attached properlyor the projector has overheated. If this light remainsorange, it indicates that you have pressed a cabinetkey while the Cabinet Button Lock is enabled. See theStatus Indicator section on page 53 for more details.4. LAMP IndicatorIf this light blinks red rapidly, it's warning you that thelamp has reached the end of its usable life. After thislight appears, replace the lamp as soon as possible(See page 50). If this is lit green continually, it indi-cates that the lamp mode is set to Eco. See the LampIndicator section on page 53 for more details.5. VIDEO ButtonPress this button to select a video source from a VCR,DVD player, laser disc player or document camera.6. S-VIDEO ButtonPress this button to select an S-Video source from aVCR, DVD player, laser disc player or document cam-era.7. COMPUTER1 and 2 Buttons (one COMPUTERport on VT47) ButtonPress this button to select an RGB source from com-puter or component equipment connected to yourCOMPUTER 1 or 2 port.8. AUTO ADJ. ButtonUse this button to adjust an RGB source for an opti-mal picture (See page 28).9. Source IndicatorsWhen one of the COMPUTER, VIDEO or S-VIDEOinput is selected, the corresponding source indicatorlights.10. MENU ButtonDisplays the menu.11. SELECT / Volume Buttons : Use these buttons to select the menu of theitem you wish to adjust. : Use these buttons to change the level of a se-lected menu item. A press of the button ex-ecutes the selection. When no menus appear,these buttons work as a volume control.12. ENTER ButtonExecutes your menu selection and activates itemsselected from the menu.13. EXIT ButtonPressing this button will return to the previous menu.While you are in the main menu, pressing this buttonwill close the menu.VT47VT676/VT670/VT575/VT470