NEC V321-2 Communications Manual

Also see for MultiSync V461: Specifications Installation and assembly User manual Specification Specifications

Contents

NEC V321-2 Communications Manual Manual pdf 25 page image

(25/37)EX.'0'-'1'(30h, 31h): Monday'0'-'4'(30h, 34h): Wednesday'0'-'F'(30h, 46h): Monday, Tuesday, Wednesday and Thursday'7'-'F'(37h, 46h): Monday to SundayFL: Optionbit 0: 0(30h):once 1(31h):Everydaybit 1: 0(30h):once 1(31h):Every weekbit 2: 0:Disable 1:EnableEX.'0'-'1'(30h, 31h): Disable, Everyday'0'-'4'(30h, 34h): Enable, onceETX (03h): End of MessageCheck codeBCC: Block Check CodeRefer to the section 4.5 “Check code” for a BCC calculation.DelimiterCR (0Dh): End of packet10.2 Schedule WriteThis command is used in order to write the setting of the Schedule.1) The controller requests the monitor to write Schedule.Header Message Check code DelimiterSOH-'0'-Monitor ID-'0'-'A'-'1'-'6' STX-'C'-'2'-'1'-'4'-PG-ON HOUR-ON MIN-OFF HOUR-OFF Min-INPUT-WD-FL-ETXBCC CRHeaderSOH (01h): Start Of Header'0' (30h): ReservedMonitor ID: Specify the Monitor ID of which you want to change a setting.Ex.) If Monitor ID is '1', specify 'A'.'0' (30h): Message sender is the controller.'A' (41h): Message type is "Command".'1'-'6'(31h, 36h): Message length.MessageSTX (02h): Start of Message'C'-'2'-'1'-'4' (43h, 32h, 31h, 34h): Schedule writes commandPG-ON HOURS-ON MIN-OFF HOURS-OFF Min-INPUT-WD-FL: Schedule dataPG: Program No.'0'-'0'(30h, 30h): Program No.1|'0'-'6'(30h, 36h): Program No.7ON_HOUR: Turn on time (hour)'0'-'0'(30h, 30h): 00|'1'-'7'(31h, 37h): 23 (=17h)'1'-'8'(31h, 38h): ON timer isn't set.ON_MIN: Turn on time (minute)'0'-'0'(30h, 30h): 0|'3'-'B'(33h, 42h): 59'3'-'C'(33h, 43h): On timer isn’t set.OFF_HOUR: Turn off time (hour)'0'-'0'(30h, 30h): 00|'1'-'7'(31h, 37h): 23 (=17h)