NEC V230 User Manual

Also see for V230: User manual Quick setup guide Quick setup guide Quick setup guide User manual

Contents

NEC V230 User Manual Manual pdf 92 page image

837. Appendix1 TroubleshootingThis section helps you resolve problems you may encounter while setting up or using the projector.Indicator MessagesPower IndicatorIndicator Condition Projector Condition NoteOff The power cord is unplugged. –Blinking light Green 0.5 sec On,0.5 sec OffThe projector is getting ready to turn on. Wait for a moment.2.5 sec On,0.5 sec OffOff Timer is enabled. –Steady light Green The projector is turned on. –Orange [NORMAL] is selected for [STANDBY MODE] –Red [POWER-SAVING] is selected for [STANDBYMODE]–Status IndicatorIndicator Condition Projector Condition NoteOff Normal or Standby ([POWER-SAVING] for[STANDBY MODE]) –Blinking light Red 1 cycle (0.5 secOn, 2.5 sec Off)Lamp cover error or lamp housing error Replace the lamp cover or lamp housing cor-rectly.2 cycle (0.5 secOn, 0.5 sec Off)Temperature error The projector is overheated. Move the projector toa cooler location.4 cycle (0.5 secOn, 0.5 sec Off)Fan error Fans will not work correctly.6 cycle (0.5 secOn, 0.5 sec Off)Lamp error Lamp fails to light. Wait a full minute and thenturn on again.Green Re-firing the lamp (The projector is coolingdown.)The projector is re-firing.Wait for a moment.Steady light Green Standby ([NORMAL] for [STANDBY MODE]) –Orange Cabinet button is locked You have pressed cabinet button when CabinetButton is locked.CONTROL ID error Remote control ID and projector ID are notmatched.Lamp IndicatorIndicator Condition Projector Condition NoteOff Normal –Blinking light Red Lamp has reached its end of life. Lamp replace-ment message will be displayed.Replace the lamp.Steady light Red Lamp has been used beyond its limit. The projec-tor will not turn on until the lamp is replaced.Replace the lamp.Green [ECO MODE] is set to [ON] –Over-Temperature ProtectionIf the temperature inside the projector rises too high, the over-temperature protector will automatically turn off the lampwith the STATUS indicator blinking (2-cycle On and Off.)Should this happen, do the following:• Unplug the power cord after the cooling fans stop.• Move the projector to a cooler location if the room where you are presenting is particularly too warm.• Clean the ventilation holes if they are clogged with dust.• Wait about 60 minutes until the inside of the projector becomes cool enough.