605. Using On-Screen MenuAdjusting Horizontal/Vertical Position [HORIZONTAL/VERTICAL]Adjusts the image location horizontally and vertically.- An image can be distorted during the adjustment of [CLOCK] and [PHASE]. This is not a malfunction.- Your manual adjustments for [CLOCK], [PHASE], [HORIZONTAL], and [VERTICAL] will be stored in memory forthe current signal. The next time you project the signal with the same resolution, horizontal and vertical frequency,its adjustments will be called up and applied.To delete adjustments stored in memory, from the menu, you select [RESET] → [CURRENT SIGNAL] or [ALLDATA] and reset the adjustments.Selecting Overscan Percentage [OVERSCAN]This allows you to set the appropriate overscan for an incoming signal.AUTO ..................... Display an appropriately overscanned image ( factory setting).OFF ........................ Does not overscan the image.ON ......................... Overscans the image.NOTE:• The [OVERSCAN] cannot be selected when VIDEO and S-VIDEO signals are used.• The [OVERSCAN] item is not available when [NATIVE] is selected for [ASPECT RATIO].Selecting Aspect Ratio [ASPECT RATIO]The term “aspect ratio” refers to the ratio of width to height of a projected image.The projector automatically determines the incoming signal and displays it in its appropriate aspect ratio.• This table shows typical resolutions and aspect ratios that most computers support.Resolution Aspect RatioVGA 640 x 480 4:3SVGA 800 x 600 4:3XGA 1024 x 768 4:3WXGA 1280 x 768 15:9WXGA 1280 x 800 16:10WXGA+ 1440 x 900 16:10SXGA 1280 x 1024 5:4SXGA+ 1400 x 1050 4:3UXGA 1600 x 1200 4:3
