NEC PlasmaSync 42XM4 Startup Manual

Also see for PlasmaSync 42XM4: Supplementary guide Supplementary guide Installation guide User manual Specifications

NEC PlasmaSync 42XM4 Startup Manual Manual pdf 7 page image

En-5VIDEO(IN/OUT)VIDEO 1VIDEO 2VIDEO 3AUDIO 1 DVD 1R( MONO)LY IN OUTREMOTEBNC connectorRCA phono plugOUTVIDEO SignalININOUTRemotecontrolVIDEO SignalRemotecontrolRGB2 / DVD2 / HD2 RGB 1R/VDG/ B/HD (IN / OUT)Cr/Pr Y Cb/Pb IN OUTREMOTEBNC connectorRGB signal/DVD/HD signalINOUTINOUTRemotecontrolRGB signal/DVD/HD signalRemotecontrolBack of the unitmounting holesTo attach To detachclampmounting hole cables1. 2.Note:1. The VIDEO1 and RGB1 terminals can be used for either INPUT or OUTPUT.When LOOP OUT is ON, do not connect an OUTPUT signal from another unit as it may damage the other unit due to anextraordinary load.2. LOOP OUT can not be turned ON while signals are input to the RGB1 terminal.3. LOOP OUT can be turned ON while signals are input to the RGB1 terminal if the POWER is switched ON.Information• To loop signals out to another plasma display, set the LOOP OUT to ON.• To create a video wall, set the VIDEO WALL menu items properly.• To connect monitors, please use a 1~2m (3.3~6.6 feet) BNC cable (any commercially available cable).• If the image quality is poor, do not use the monitor’s out terminal. Use a distribution amplifier (any commerciallyavailable distribution amplifier) to connect the split signals to the respective monitor INPUT terminals.• Being used as a video wall function, maximaly 4-screen is rough-standard with lower than 1024768, 60Hzsignal.• A distribution amplifier is particularly recommended when creating a 33 (or greater) video wall.• When looping from plasma to plasma, a 1~2m (3.3~6.6 feet) 15 pin male D-Sub - 5BNC conversion cable isrequired.Creating a video wallWith built-in matrix display capability, you can create a (22, 33, 44, 55) video wall.• Connect signal cables and remote cables as shown below.Video signal RGB/DVD/HD signalCable ManagementUsing the cable clamps provided with the plasma display;Bundle the signal and audio cables at the back of the unitto connect to the display.