NEC PlasmaSync 4210W User Manual

Contents

NEC PlasmaSync 4210W User Manual Manual pdf 20 page image

13Basic OperationsPOWERTo turn the unit ON and OFF:1. Plug the power cord into an active AC power outlet.2. Press the POWER button (on the remote controller) toturn on.The monitor’s POWER/STANDBY indicator will lightup(green) when the unit is on.3. Press the POWER button (on the remote controller orthe unit) to turn off.The monitor’s POWER/STANDBY indicator turns redand the standby mode is set (only when turning off theunit with the remote control).VOLUMETo adjust the volume:1. Press and hold the VOLUME s button (on the remotecontroller or the unit) to increase to the desired level.2. Press and hold the VOLUME t button (on the remotecontroller or the unit) to decrease to the desired level.MUTETo cancel the sound:Press the MUTE button on the remote controller to cancelsound; press again to restore.DISPLAYTo check the settings:1. The screen changes each time the DISPLAY button ispressed.2. If the button is not pressed for approximately three sec-onds, the menu turns off.VISUAL CONTROLTO adjust the picture's contrast:1, Press and hold the CONTRAST s button for highercontrast.2, Press and hold the CONTRAST t button for lowercontrast.TO adjust the picture's brightness:1, Press and hold the BRIGHT s button for a brighterpicture.2, Press and hold the BRIGHT t button for a darker pic-ture.TO adjust the picture's color:1, Press and hold the COLOR s button for more colorsaturation.2, Press and hold the COLOR t button for less color satu-ration.TO adjust the picture's tint (NTSC only):1, Press and hold the TINT s button for a greener tint.2, Press and hold the TINT t button for a redder tint.TO adjust the picture's sharpness:1, Press and hold the SHARPNESS s button for a sharperpicture.2, Press and hold the SHARPNESS t button for a softerpicture.*If no key operation is made within five seconds, the OSMdisplay will disappear.