985. Using On-Screen Menu[LAMP MODE]When eco-mode is set to [ON], the CO2 emissions (calculated from the reduction in power consumption) of the projec-tor can be reduced. The eco-mode reduces power consumption by mainly lowering the brightness of the lamp. As aresult, the lamp replacement time (as a guide)* is extended. (→ page 118)* Replacement time not guaranteed.LAMP ADJUST������� This can be set when the eco-mode is set to [OFF]� Adjust the lamp to match the brightness of each projectorwhen projecting a multi-screen display using multiple projectors�ECO MODE OFF The lamp luminance (brightness) will become 100% and the screen will turn bright.The luminance of the lamp can be set using the lamp adjustment.ON The lamp luminance (brightness) will become approximately 80% and the lamp replacement time(estimated)* will be extended.* The replacement time is not guaranteed.LAMP ADJUST When the [ECO MODE] is set to [OFF], [LAMP ADJUST] is enabled.Adjust the lamp to match the brightness of each projector when projecting a multi-screen displayusing multiple projectors.[REF. WHITE BALANCE]This feature allows you to adjust the white balance for all signals.The white and black levels of the signal are adjusted for optimum color reproduction.Uniformity is also adjusted when the redness (R) and blueness (B) of the white color in the screen’s horizontal (left/right) direction are uneven.CONTRAST R/CONTRAST G/CONTRAST B������������������������������ These adjust the picture’s white color�BRIGHTNESS R/BRIGHTNESS G/BRIGHTNESS B������������������������������ These adjust the picture’s black color�UNIFORMITY R ������ The further this is set to the + side, the stronger the redness on the left side of the picture (increasingtowards the left edge) and the weaker the redness on the right side of the picture (decreasing towards theright edge)�This is reversed when set to the – side�UNIFORMITY B ������ The further this is set to the + side, the stronger the blueness on the left side of the picture (increasingtowards the left edge) and the weaker the blueness on the right side of the picture (decreasing towards theright edge)�This is reversed when set to the – side�[STATIC CONVERGENCE]This features allows you to adjust for color deviation in the picture.This can be adjusted in units of ± 1 pixel in the horizontal direction for HORIZONTAL R, G and B, in the vertical direc-tion for VERTICAL R, G and B.
