1616. Installation and ConnectionsHDMI IN AUDIO INHDMI OUTAUDIO OUTConnecting an External MonitorYou can connect a separate, external monitor to your projector to simultaneously view on a monitor the computeranalog image you’re projecting.• Please refer to Page 67 when displaying the [PIP/PICTURE BY PICTURE] screen.NOTE:• When outputting HDMI signals, turn on the power of the video device on the output side and keep it connected before inputtingvideo signals into this device. The HDMI output terminals of the projector are equipped with repeater functions. When a device isconnected to the HDMI output terminal, the resolution of the output signal is limited by the resolution supported by the connecteddevice.• Connecting and disconnecting an HDMI cable or selecting another input source on the second and subsequent projectors willdisable the HDMI repeater function.• In the case of the HDMI output terminal of the projector, the theoretical number of units that can be connected in a series is seven.The maximum number of units that can be connected may be reduced by the external environment and quality of the signal andcable, etc. The number of units that can be connected may differ depending on the HDCP version, restriction on the number ofHDCP repeaters in the source device and the quality of the cable. The overall system needs to be checked in advance when build-ing a system.• When audio equipment is connected, the projector speaker is disabled.• To output audio from the audio output terminal when the input terminal is neither “COMPUTER IN” nor “BNC IN”, select [BNC]under [AUDIO SELECT] of the on-screen menu.• When the [STANDBY MODE] is set to [NORMAL], video and audio will not be output when the projector is set to the standbymode. Set the standby mode to [NETWORK STANDBY] for MM models. For HDBaseT models, set the standby mode to [HDBaseTSTANDBY], turn on the power supply to the transmission device and keep the unit in a connected state.• For HDBaseT models, HDMI signals will not be output when the [STANDBY MODE] of the projector is set to [NORMAL]. To outputa HDMI signal, set the [STANDBY MODE] to [HDBaseT STANDBY], turn on the power supply of the transmission device and keepthe unit in a connected state.• Both the composite video signal from each input connector as the computer, BNC, and BNC (CV), and the S-video signal fromthe BNC (Y/C) Input connector are not output from HDMI OUT Connector of this projector.Computer cable (VGA)(not supplied)Stereo mini-plug audio cable(not supplied)HDMI cable (not supplied)
