1295. Using On-Screen Menu[POWER OPTIONS]Selecting Power-saving in [STANDBY MODE]Setting the power consumption in the standby mode.NORMAL���������������� In the standby mode, the power consumption of the projector is 0�11 W (100-130 V)/0�16 W (200-240 V)�In the standby mode, the POWER indicator lights up in red while the STATUS indicator will go off�• When set to [NORMAL], the following terminals and functions will be disabled. HDMI output terminal,Audio output terminal, Ethernet/HDBaseT port (Ethernet port for MM models), USB-A port, LAN function,[ALERT MAIL] functionHDBaseT STANDBY (HDBaseT Models)/NETWORK STANDBY (MM Models)������������������������������ Compared to [NORMAL], the power consumption in the standby mode is higher but power can be suppliedto the projector using a wired LAN�In the standby mode, the power indicator will light up in orange while the status indicator will be turnedoff�Important:• When [HDBaseT STANDBY] ([NETWORK STANDBY] for MM models) is selected, [AUTO POWER OFF] turns grey in colour andbecomes disabled while [0:15] is selected compulsorily.• When it is set to [HDBaseT STANDBY] ([NETWORK STANDBY] for MM models), under the following conditions, the [STANDBYMODE] setting is disabled and the unit will go into the sleep mode*.* Sleep mode refers to the mode whereby the functional restrictions due to the [STANDBY MODE] setting are removed.• When [ENABLE] is selected under [NETWORK SERVICE] → [AMX BEACON]• When [NETWORK SERVICE] → [CRESTRON] → [CRESTRON CONTROL] → [ENABLE] is selected• When [CONTROL] → [REMOTE SENSOR] → [HDBaseT] is selected (only for HDBaseT models)• Signal being received from the HDBaseT transmission device (only for HDBaseT models)• When [NORMAL] is selected, the [AUTO POWER ON SELECT] display turns grey in color and is disabled, and [OFF] is automati-cally selected.NOTE:[HDBaseT Models]• When connecting to a HDBaseT transmission device sold commercially, if the transmission device is set to transmit remote controlsignals, the power consumption of the projector in the standby mode will increase.TIP:• Your setting will not be affected even when [RESET] is done from the menu.• The power consumption in the standby mode will not be included in calculating CO2 emission reduction.Enabling Direct Power On [DIRECT POWER ON]Turns the projector on automatically when the power cord is inserted into an active power outlet. This eliminates theneed to always use the POWER button on the remote control or projector cabinet.
