NEC NP1250 Network Setup Manual

Also see for NP1250 Series: Control commands Command guide Command guide Supplementary guide Specifications

Contents

NEC NP1250 Network Setup Manual Manual pdf 19 page image

194. Configuring the LAN Settings of the ProjectorConfiguring the LAN Settings of the Projector44-2. Wireless LANWhen connecting the wireless LAN, configure the LAN settings in the “WIRELESS” page of“NETWORK SETTINGS” selected from On-Screen Menu.Noten Configuration flowchartSetting of “CONNECTION”.Select SSID in “SITE SURVEY”.Input “SSID” (if necessary).Select “NETWORK TYPE” (if necessary).Select “CHANNEL” (if necessary).Setting of “SECURITY”Select “SECURITY TYPE”.Select “KEY SELECT”.Set “KEY 1 to KEY 4”.If “EASY CONNECTION” is selected889101112131415161613Step Display “WIRELESS” page of “NETWORK SETTINGS”.4Step Input “IP ADDRESS”.2Step Select “PROFILES”.5Step Input “SUBNET MASK”.6Step Input “GATEWAY”.7Step Input “DNS CONFIGURATION”.17Step Confirm the “ADVANCED” settings.18Step Reconnect to the network.19Step Confirm the settings.Step - Setting of “ADVANCED”.Step Enable or disable “DHCP”.If “Disabled” (without check mark) If “Enabled” (with check mark)The wireless LAN cannot be used with VT800.