202. Projecting an Image (Basic Operation) Selecting a SourceSelecting the computer or video sourceNOTE: Turn on the computer or video source equipment connected to the projector.Detecting the Signal AutomaticallyPress the SOURCE button once. The projector will search for the availableinput source and display it. The input source will change as follows:COMPUTER1 → COMPUTER2 → COMPUTER3 → HDMI → DisplayPort→ VIDEO → S-VIDEO → VIEWER → SLOT → COMPUTER1 → ...• With the SOURCE screen displayed, you can press the SOURCEbutton a few times to select the input source.TIP: If no input signal is present, the input will be skipped.Using the Remote ControlPress any one of the COMPUTER1, COMPUTER2, COMPUTER3, HDMI,DisplayPort, VIDEO, S-VIDEO, VIEWER, or NETWORK buttons.Selecting Default SourceYou can set a source as the default source so that it will be displayedeach time the projector is turned on.1. Press the MENU button.The menu will be displayed.2. Press the button twice to select [SETUP] and press the but-ton or the ENTER button to select [BASIC].3. Press the button five times to select [OPTIONS(2)].4. Press the button five times to select [DEFAULT SOURCESELECT] and press the ENTER button.The [DEFAULT SOURCE SELECT] screen will be displayed.(→ page 129)5. Select a source as the default source, and press the ENTER but-ton.6. Press the EXIT button a few times to close the menu.7. Restart the projector.The source you selected in step 5 will be projected.NOTE: Even when [AUTO] is turned on, the [NETWORK] will not be automaticallyselected. To set your network as the default source, select [NETWORK].TIP:• When the projector is in Standby mode, applying a computer signal from acomputer connected to the COMPUTER 1/3 IN input will power on the projectorand simultaneously project the computer’s image.([AUTO POWER ON(COMP1/3)] → page 129)• On the Windows 7 keyboard, a combination of the Windows and P keys allowsyou to set up external display easily and quickly.
