263. Convenient Features Changing Eco Mode/Checking Energy-Saving EffectUsing Eco Mode [ECO MODE]The ECO MODE (ECO1 and ECO2) increases lamp life, while lowering power consumption and cutting down on CO2emissions.Four brightness modes of the lamp can be selected: [OFF], [AUTO ECO], [ECO1] and [ECO2] modes.[ECO MODE] Description Status of LAMP indicator[OFF] This is the default setting (100% Brightness). Off[AUTO ECO] Lamp power consumption will be changed between[OFF] and [ECO1] automatically according to picturelevelNOTE: A bright gradation may be less visible dependingon the image.Steady Greenlight[ECO1] Low lamp power consumption (approx. 75% Bright-ness on M350X/M300W and approx. 80% Brightnesson M300X/M260X/M230X/M260W).[ECO2] (M300Xand M260X only)Lower lamp power consumption than [ECO1] mode(approx. 50% Brightness)To turn on the [ECO MODE], do the following:1. Press the ECO Button on the remote control to display [ECO MODE] screen.2. Press the ECO button again to select a mode you wish.• Each time the ECO button is pressed, the choices will be changed:OFF → AUTO ECO → ECO1 (→ ECO2) → OFF• When the projector is in ECO mode, the LAMP indicator will light green.TIP:• The leaf symbol at the bottom of the menu shows the current selection of ECO mode.2. Press the button.The area of the magnified image will be moved3. Press the D-ZOOM (−) button.Each time the D-ZOOM (−) button is pressed, the image is reduced.NOTE:• The image will be enlarged or reduced at the center of the screen.• Displaying the menu will cancel the current magnification.Downloaded From projector-manual.com NEC Manuals
