182. Projecting an Image (Basic Operation)213Adjustable Tilt FootAdjustable TiltFoot LeverAdjust the Tilt Foot1. Lift the front edge of the projector.CAUTION:Do not try to touch the ventilation outlet during Tilt Foot adjustmentas it can become heated while the projector is turned on and after itis turned off.2. Push up and hold the Adjustable Tilt Foot Lever on the front ofthe projector to extend the adjustable tilt foot.3. Lower the front of the projector to the desired height.4. Release the Adjustable Tilt Foot Lever to lock the Adjustable tiltfoot.The tilt foot can be extended up to 1.6 inch/40 mm.There is approximately 10 degrees (up) of adjustment for the front ofthe projector.Rotate the rear foot to the desired height in order to square the imageon the projection surface.CAUTION:• Do not use the tilt-foot for purposes other than originally intended.Misuses such as using the tilt foot to carry or hang (from the wall orceiling) the projector can cause damage to the projector.Adjusting the left and right tilt of an image [Rear foot]• Rotate the rear foot.The rear foot can be extended up to 0.5 inch/12 mm. Rotating the rearfoot allows the projector to be placed horizontally.NOTE:• Do not extend the rear foot beyond its height limit (0.5 inch/12 mm). Doing somay cause the rear foot to come out of the projector.Rear footUp DownDownloaded From projector-manual.com NEC Manuals
