NEC AccuSync AS171 User Manual

Also see for AccuSync AS171: Specifications Brochure & specs Specifications Specifications

Contents

NEC AccuSync AS171 User Manual Manual pdf 7 page image

EnglishEnglish-5Macintosh Cable Adapter(not included)ContentsYour new NEC AccuSync LCD monitor box* should contain the following:• AccuSync LCD monitor with tilt base• Power Cord• Video Signal Cable (15-pin mini D-SUB male to 15-pin mini D-SUB male)• Setup Manual• Base Stand• Cable HolderSetup Manual Power Cord* 1 Video Signal Cable Base Stand AccuSync LCD monitor(base stand not connected)Cable Holder*Remember to save your original box and packing material to transport or ship the monitor.*1Type of power cord included will depend on the where the LCD monitor is to be shipped.SetupManualQuick StartTo attach the Base Stand to the LCD Stand:1. Attach the Base Stand to the Stand. The locking tabs on the Base Stand should fitinto the hole on the Stand (Figure S.1).To attach the AccuSync LCD monitor to your system, follow these instructions:1. Turn off the power to your computer.2. For the PC or MAC with DVI digital output: Connect the DVI signal cable (notincluded) to the connector of the display card in your system (Figure A.1).Tighten all screws.For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable tothe connector of the display card in your system (Figure A.2). Tighten all screws.For the MAC: Connect the Macintosh cable adapter (not included) to the computerand then attach the 15-pin mini D-SUB signal cable to the Macintosh cable adapter(Figure A.3). Tighten all screws.NOTE: Some Macintosh systems do not require a Macintosh cable adapter.Figure A.1 Figure A.2 Figure A.3DVI Signal Cable (not included)Figure S.1StandBase Stand