NEC AccuSync AS171 User Manual

Also see for AccuSync AS171: Specifications Brochure & specs Specifications Specifications

Contents

NEC AccuSync AS171 User Manual Manual pdf 13 page image

EnglishEnglish-11SpecificationsMonitor Specifications AccuSync AS171 Monitor NotesLCD Module Diagonal: 43.2 cm/17.0 inches Active matrix, thin film transistor (TFT)Viewable Image Size: 43.2 cm/17.0 inches liquid crystal display (LCD); 0.264 mm dotNative Resolution (Pixel Count): 1280 x 1024 pitch; 250 cd/m 2 white luminance, 900:1contrast ratio, typical.Input Signal 15pin Mini D-sub: Analog RGB 0.7 Vp-p/75 ohmsSync Separate sync. TTL level (Positive/Negative)DVI-D Digital RGB DVI(HDCP)Display Colors Analog input: 16.7 M Depends on display card used.Viewing Angle Left/Right: -80°/+80° (CR>10)Up/Down: -80°/+80° (CR>10)Synchronization Range Horizontal: 31.5 kHz to 81.1 kHz AutomaticallyVertical: 56 Hz to 76 Hz AutomaticallyResolutions Supported Landscape: 720 x 400* 1: VGA text Some systems may not support all640 x 480* 1 at 60 Hz to 75 Hz modes listed.800 x 600* 1 at 56 Hz to 75 Hz832 x 624* 1 at 75 Hz1024 x 768* 1 at 60 Hz to 75 Hz1152 x 864* 1 at 75 Hz1152 x 870* 1 at 75 Hz1280 x 960* 1 at 60 Hz to 75 Hz Recommended resolution is 60 Hz for1280 x 1024 at 60 Hz to 75 Hz.....................optimal display performance.Active Display Area Horizontal: 337.9 mmVertical: 270.3 mmPower Supply 100 - 240 V ~ 50/60 HzCurrent Rating 0.5 - 0.3 APower Maximun Operation: 22 WConsumption Normal Operation: 18 WDimensions Landscape: 373.2 mm (W) x 373.1 mm (H) x 205.1 mm (D)14.7 inches (W) x 14.7 inches (H) x 8.1 inches (D)Weight 3.9 kg (8.6 lbs)Environmental ConsiderationsOperating Temperature: 5°C to 35°C/41°F to 95°FHumidity: 20% to 80%Altitude: 0 to 2,000 m/0 to 6,562 FeetStorage Temperature: -10°C to 60°C/14°F to 140°FHumidity: 10% to 85%Altitude: 0 to 12,192 m/0 to 40,000 Feet*1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This isnormal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each dot onthe screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.NOTE: Technical specifications are subject to change without notice.