NAPCO Gemini GEM-X255 Installation Instructions Manual

Also see for Gemini GEM-RP1CAe2: Installation instructions Installation instructions Installation instructions Installation instructions Operating guide

NAPCO Gemini GEM-X255 Installation Instructions Manual Manual pdf 13 page image

L NAPCO Security Systems X GEM-X255 Installation InstructionsWI1093C 3/04 !Page 13TESTING THE SYSTEMAfter installation is completed, test the system as follows.! 1. Call the central station to inform them of the test.! 2. Initiate an alarm, preferably on a zone that activates a steady siren, and verify proper signaling.! 3. Wait 5 minutes.! 4. Call the central station to confirm their receipt of a good transmission.Note: Be sure to test all enabled keypad panics.Signal Strength Testing/Wireless SystemsTo test the operation of wireless transmitters, proceed as follows. (Note: Wireless systems have not been investigatedby UL).! Fault a point of each transmitter to be tested by faulting the zone.The transmitter signal strength can be displayed using the DISPLAY RF XMITTER STAT function. Enter a Level 3 UserCode or enter the Dealer Code, press the A button and answer NO until ìDISPLAY RF XMITTER STATî is dis-played. Press YES (E button) and the Wireless Signal Strength of the wireless zone will be displayed. The Wire-less Signal Strength will be displayed from 1 to 10 with 10 being the strongest signal and any signal under 3 as unac-ceptable. Except in the Fault-Find Mode, signal strengths less than 3 will be entered into the system log. Press NEXT(E button) to step the next zone.The last received signal strength for each transmission is always stored in memory and can viewed at any time usingthis procedure. Signal strength can also be viewed through the PCD-Windows Status Screen.INSTALLATION