NAPCO GEM-RP4C Operating Manual

Also see for Gemini GEM-RP4C: Installation instructions Programming instructions

Contents

NAPCO GEM-RP4C Operating Manual Manual pdf 6 page image

6S E T T I N G T H E AL AR M ( AR M I N G ) W H E N L E AV I N GArming the System1. Check the keypad. The green STATUS light must be on in order to arm.If the green light is off, the number(s) of any unsecured zone(s) will display inthe window. Refer to the pull-up zone list for the location of each problemzone and secure by closing windows, doors, etc.. When all zones are secure,the green STATUS light will come on.2. Arm the system. Enter your User Code followed by D. The green STATUSlight will go off, the red ARMED light will come on. Note: If you enter an invalidcode, the keypad will beep 4 times, indicating an error. Re-enter your code.3. Leave the premises. Leave through the exit door before the exit time expires.Priority ArmingIf you attempt to arm the system with a faulted Zone, a 3-second tone will soundat the keypad and “P” will display in the window, indicating that the zones must besecured before the panel can be armed.Selectively Bypassing ZonesIf you cannot locate or repair a faulted zone, it can be removed from the system,or bypassed. Bypass the zone(s) from the system by pressing B, followed bythe zone number (or vice versa). The BYPASS icon in the display will turn on toindicate that the zone has been bypassed.Note: Bypassed zones are unprotected. If a faulted zone cannot be secured,have the system checked as soon as possible.CHIME12CHIMEPCHIMEBYPASS