NAD M55 Owner's Manual

Also see for M55: Technical bulletin Owner's manual Specifications Owner's manual Service manual

NAD M55 Owner's Manual Manual pdf 21 page image

21ENGLISHFRANÇAISDEUTSCHNEDERLANDSESPAÑOLITALIANOPORTUGUÊSSVENSKADOLBY PRO LOGIC SURROUND SOUNDOne can enjoy the high quality sound of Dolby Pro Logic Surround Sound if your A/V receiver is equipped with a Dolby Pro Logic Surround Soundprocessor or decoder.CONNECTING TO A SURROUND SOUND SYSTEMSetupTVFrom theMIXED AUDIO L/R jacks75-Ohm audio cablesFrom S-VIDEO / Component Video /Composite or SCARTS-VIDEO / Component / Composite75–Ohm coaxial or SCART cableTo S-VIDEO / Component / Composite orSCART inputs of the receiverConnection example To RCA audio input jacks ofthe surround sound receiverequipped with a Dolby ProLogic decoder To audio inputFront Speaker(left)Front speaker(right)Centre speakerRear speaker (left) Rear speaker (right)To enjoy Dolby Pro Logic soundfrom this DVD player you need thefollowing:• DVD recorded in Dolby ProLogic format.• Dolby Pro Logic A/V receiverequipped with a Dolby ProLogic decoder, or Dolby ProLogic decoder and poweramplifier• 5 speakersTVWITH A RECEIVER EQUIPPED WITH A DOLBY PROLOGIC DECODERConnect the Speakers and receiver equipment the same way as described in Enjoying Dolby Digital Sound. Then connect two channel 75 Ohm audiocables as above. Refer to that A/V receiver’s owner’s manual and set the receiver so you can enjoy Dolby Pro Logic Surround sound.You must select a type is a surround-compatible Downmix (Left-total/Right-total, or Lt/Rt) of the multichannel source suitable for Dolby Pro Logic II,Dolby Pro Logic IIx, or other matrix decoding. From the Setup OSD, you need to select, Audio, Downmix, and then ‘Lt/Rt’ for multi-channel matrixdecoding.WARNINGDo not connect the Digital Audio Output of this DVD player to your receiver unless you are connecting the DIGITAL OUT jack of this DVD playerto an AV decoder that has the Dolby Digital or DTS decoding function. High volume sound may damage your hearing as well as the speakers(Refer to Selecting Digital Audio Output. (Refer to Initial Setup Settings, Audio)NOTESRefer to the owner’s manual of your audio equipment as well. When you connect the M55 to other equipment, be sure to turn off the powerand unplug all of the equipment from the wall outlet before making any connections. The output sound of the M55 has a wide dynamic range.Be sure to adjust the receiver’s volume to a moderate listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.Turn off the receiver before you connect or disconnect the M55’s power cord. If you leave the receiver power on, the speakers may be damaged.