NAD D 3045 Owner's Manual

Also see for D 3045: Quick setup guide Quick setup guide

Contents

NAD D 3045 Owner's Manual Manual pdf 5 page image

ENGLISH1 o (STANDBY)• With the corresponding end of the mains power cord connectedto the AC mains input of the D 3045 and the plug connected to amains power source, press o (Standby) to switch ON the D 3045from standby mode. The Standby indicator will turn from amber tobright color.• Press and hold o (Standby) until D 3045 switches back to standbymode.2 VOLUME• Rotate Volume knob clockwise or counterclockwise to adjust audiolevel.• Rotating the Volume knob will automatically restore audio frommute mode.3 SOURCE• Rotate clockwise or counterclockwise to select desired Source.4 DISPLAY• Sources, audio level and other indicators are shown.• Display follows the orientation of the unit - vertical or horizontalview.IMPORTANT NOTEDisplay will temporarily turn off if there is no user interface interactionwithin 5 minutes. Restore display by sending a remote control commandor rotating any of the controls.5 PHONES• Use the 3.5 mm stereo jack socket for headphone listening.• Specially designed low noise headphone circuitry can accommodate awide range of phones, even 600 Ohm studio models.• Adjust headphone audio level by rotating the VOLUME controlclockwise or counterclockwise.• Ensure that the volume control is turned to minimum (fullycounterclockwise) before connecting or disconnectingheadphones. Listening at high levels can damage your hearing.• Inserting a headphone jack into this socket automatically switchesoff the loudspeakers.6 GROUND TERMINAL• If a separate earth ground is necessary, use this terminal toground your D 3045. The D 3045 can be connected to ground byconnecting a ground lead wire or similar to this terminal. Afterinsertion, tighten the terminal to secure the lead.NOTES• Consult with a licensed electrician to properly locate or correctlyinstall a grounding conductor in your home. NAD is not responsiblefor any malfunction, damage or costs associated with the installation,connection or grounding of your D 3045.• The grounding wire is not supplied with your D 3045.7 PHONO (MM)• Input for a Moving Magnet (MM) phono cartridge only. Connect thetwin RCA lead from your turntable to this input if you are using aMoving Magnet cartridge.8 LINE 1• Connect to corresponding analog output of other audio devicesusing a 3.5mm stereo plug to RCA connector adapter (notsupplied).9 LINE 2• Connect to corresponding analog output of a CD player,preamplifier, processor or other applicable devices using RCA-to-RCA stereo cable (not supplied).IDENTIFICATION OF CONTROLS5+12VTRIGGERINLINE 1PHONO(MM)COAXIALLINE 2 PRE / SUBOUTOPTICAL 1 OPTICAL 2HDMIARC100-120V~60Hz / 220-240V~50HzCOMPUTER6 7 8 9 1011 12 13 14 15 16 1712345