N-Tron 7018 Series User Manual & Installation Manual

Also see for 7018: Technical instructions

Contents

N-Tron 7018 Series User Manual & Installation Manual Manual pdf 45 page image

(Revised 8/3/2009) Page 45 of 138Ports – TrunkingThe Trunking tab under the Ports category displays the following details:Trunk PortsThis field displays the ports associated with the trunk.Trunk StatusThis configurable field displays the existing status of the trunk. It can be either Enabled/Disabled.By selecting the Modify button, you can select a trunk group.Note: RSTP must be disabled in order to use the Trunking feature.Two ports of the same speed can constitute a valid trunk.Only 1 Trunk per switch can be created.All trunk ports must be at the same speed and duplex mode. If a port is not linked, there could bedifficulty as to similar speed and duplex mode. It is best to hard code speed and duplex mode foreach trunking link, at both ends.Do not use Trunking on an N-Ring manager. Do not connect the N-Ring to actively Trunking portson an Auto Member.