N-Tron 508TX Installation Manual

Also see for 500 Series: Installation guide

Contents

N-Tron 508TX Installation Manual Manual pdf 23 page image

(Revised 2013-06-21) 23System MenuCommand Description Commentnview Get information aboutN-View TM function.aging Set and get info on Aging Time fordynamically learned addressesinfoorinfo1, info2,...Displays the current system status. (info for508/9)(info1,2 for 516/7)(info1,2,3,4 for 524)(info1,2,3,4 for 526)LINK Status. Rate, Flow, etc.upwd Set a user defined password.restore Restores the defaults of the switch (completereset). **Note: Power cycle is requiredwhen completed.restores the factory settings of the switch. With theexception of the “protected settings” (see‘Restoring Defaults’), the settings made by the userare reset to the default values.N-ViewTM MenuWith the N-ViewTM OPC software and an appropriate OPC viewer, one can monitor port and switch statusvia the LAN. When enabled, periodic Multicast MAC packets are sent out from every port.Note: The configuration console is only available with –A models.Command Description Commentinfo Displays the current values of theswitch settingsMAC address,Enabled or disableddisable (or enable) Enable or Disable N-ViewTM Choice is opposite of current stateNotes on N-ViewTM: With ‘-A’ option, either all ports are ‘on’, or all ports are ‘off’. With the ‘-N’ option all ports are ‘on’. Rate for generation of MIB information frames is ~6.4 seconds. The N-ViewTM frames are not mirrored. The FX Port is mapped to port 9 on the 509, and as port 17 on the 517. On the 508FX2, ports 7 and 8 are FX ports. Onthe 526FX, Ports 25 and 26 are FX ports.Example of the N-View info screen:CLI\SYSTEM\N-VIEW>infoN-View is ENABLED.MAC ADDRESS:00-07-AF-00-05-26/ (Go to top of menu tree)? (Show menus/commands)info (Get information about N-View)disable (Disable N-View)CLI\SYSTEM\N-VIEW>