Manitowoc Q Q160 Installation Use And Care Manual

Contents

Manitowoc Q Q160 Installation Use And Care Manual Manual pdf 26 page image

Maintenance Section 4Re-Installing the Paddle Wheel Guard1 When re-assembling the rocking chute/door, thepaddle wheel guard is placed in the slot in the icechute.Notice that a cylinder hinge is welded to the topfront side of the paddle wheel guard, as shown inthe picture above.When the paddle wheel guard is placed in the slotin the ice chute, the cylinder hinge on the front ofthe paddle wheel guard faces forward, as shownin the picture above.When the paddle wheel guard is correctlyinstalled, the paddle wheel guard will swingoutward toward the front of the chute, allowingice to flow out of the chute.If incorrectly installed, the paddle wheel guardwill not swing outward and ice delivery isblocked.CylinderhingeWelded toFront ofPaddle wheelGuardCorrect InstallationSlot inChute PaddlewheelguardPaddlewheelguard(front)2 Correct Installation:If you press your finger forward against thepaddle wheel guard, the paddle wheel guard doesnot swing back open.Incorrect InstallationPaddlewheelguard3 Incorrect Installation:If you press your finger forward against thepaddle wheel guard, the paddle wheel guard doesswing back open.4-6