Manitowoc K00049 Installation Instructions Manual

Also see for E-0400: Installation instructions Installation instructions

Contents

installation instructions

Manitowoc K00049 Installation Instructions Manual Manual pdf 1 page image

K00049 STACKING KITInstallation InstructionsThese instructions are for stacking an E-0400, G-0400, or G-0600 ice machine on a G-1200 ice machine. The bin must belevel before proceeding.PARTS LIST:Item Description Qty. P/N1. Ice Chute Weldment 1 66397142. Top Cover 1 68709143. Water Shield 1 66398144. Top Mounting Bracket 1 66399145. Bottom Mounting Bracket 1 66400146. Bin Thermostat 1 60250147. Bin Thermostat Bulb Mounting Bracket 1 60913148. Electrical Box Front Cover 1 62070149. Tie Plate 1 627301410. Installation Instructions 1 800329311. Label - Wiring Diagram 1 810624312. RTV Sealer (3 oz. tube) 1 910069113. Foam Tape 114" 920248314. Screw #10-24 x 5/8" P.P.H.T.C. 5 520205315. Screw #10-24 x 3/8" Slotted Hex Hd. TCS 3 520210316. Screw #8 x 1/2" S.M.S. 1 512153117. Wing Nut #8-32 4 54890211. INSTALLATION OF BIN THERMOSTAT BRACKET:A. Locate the bin, as shown in Illustration 1.2. INSTALLATION OF G-1200 ICE MACHINE:A. See service manual for uncrating and inspection of ice machine.B. Remove top cover from ice machine.C. Set ice machine carefully and squarely on bin.D. Position top cover from kit on right-hand side of ice machine. Attach water shield from kit to top cover using one #8 x1/2" long sheet metal screw from kit (see Illustration 2).E. Apply foam tape from kit, as shown in Illustration 23. INSTALLATION OF E-0400, G-0400, OR G-0600 ICE MACHINE:NOTE: G-0600 IS USED TO REPRESENT ANY E-0400, G-0400, OR G-0600.A. See service manual for uncrating and inspection of ice machine.B. Remove top cover from ice machine.C. Position G-0600 ice machine on G-1200 ice machine with back and left sides being flush.Attach machines together using the tie plate from kit on left side of machines. Remove the right side panel from theG-0600 ice machine. Drill a 5/32" diameter hole in top cover using an existing hole in the bottom angle of the G-0600ice machine as a guide. NOTE: Be sure not to damage internal parts of the G-1200 ice machine (see Illustration 3).D. Before applying RTV sealant in designated areas to insure against leaks or water hang-ups (as shown in Illustration 4),remove the water pump, high and low valve plastic cover, water curtain, and water trough. After sealing seams withRTV, replace water pump, water curtain, high and low valve plastic cover, and water trough.Manitowoc Ice, Inc.2110 South 26 Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA 8003293Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879 Sheet 1 of 10Web Site - www.manitowocice.com Rev. 05/17/014. INSTALLATION OF BIN THERMOSTAT BULB:

/ 3

Related manuals for Manitowoc E-0400