Makita VR001C User Manual

Also see for VR001C: Instruction manual Instruction manual Instruction manual

2ENGLISHENGLISH: Original instructionsINTENDED USEThe tool is intended for removing bubbles from concrete when casting concrete.NOISEThe typical A-weighted noise level determined accordingto EN60745:Model: VR001C, VR002CSound power level (LWA ): 98.4 dB (A)Sound pressure level (L pA ): 87.4 dB (A)Uncertainty (K): 3 dB (A)Model: VR003C, VR004CSound power level (LWA ): 97.6 dB (A)Sound pressure level (L pA ): 86.6 dB (A)Uncertainty (K): 3 dB (A)NOTE: The declared noise emission value(s) has beenmeasured in accordance with a standard test methodand may be used for comparing one tool with another.NOTE: The declared noise emission value(s) may alsobe used in a preliminary assessment of exposure.WARNING: Wear ear protection.WARNING: The noise emission during actualuse of the power tool can differ from the declaredvalue(s) depending on the ways in which thetool is used especially what kind of workpiece isprocessed.WARNING: Be sure to identify safety measuresto protect the operator that are based on anestimation of exposure in the actual conditions ofuse (taking account of all parts of the operating cyclesuch as the times when the tool is switched off andwhen it is running idle in addition to the trigger time).VIBRATIONThe vibration total value (tri-axial vector sum) determinedaccording to EN60745:Model: VR001C, VR002CWork mode: operation without loadVibration emission (ah): 1.9 m/s2 (Hose)Vibration emission (ah): 0.7 m/s2 (Inverter case)Uncertainty (K): 1.5 m/s2Model: VR003C, VR004CWork mode: operation without loadVibration emission (ah): 3.1 m/s2 (Hose)Vibration emission (ah): 1.7 m/s2 (Inverter case)Uncertainty (K): 1.5 m/s2NOTE: The declared vibration emission value hasbeen measured in accordance with a standard testmethod and may be used for comparing one tool withanother.NOTE: The declared vibration emission value mayalso be used in a preliminary assessment of exposure.WARNING: The vibration emission during actualuse of the power tool can differ from the declaredemission value depending on the ways in whichthe tool is used especially what kind of workpieceis processed.WARNING: Be sure to identify safety measuresto protect the operator that are based on anestimation of exposure in the actual conditions ofuse (taking account of all parts of the operating cyclesuch as the times when the tool is switched off andwhen it is running idle in addition to the trigger time).EC Declaration of conformityFor European countries onlyThe EC declaration of conformity is included as Annex A to this instruction manual.