Makita LS1018L Instruction Manual

Also see for LS1018: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

9Vibration emission (ah ) : 2.5 m/s 2 or lessUncertainty (K) : 1.5 m/s 2ENG901-1• The declared vibration emission value has beenmeasured in accordance with the standard testmethod and may be used for comparing one toolwith another.• The declared vibration emission value may also beused in a preliminary assessment of exposure.WARNING:• The vibration emission during actual use of thepower tool can differ from the declared emissionvalue depending on the ways in which the tool isused.• Be sure to identify safety measures to protect theoperator that are based on an estimation ofexposure in the actual conditions of use (takingaccount of all parts of the operating cycle such asthe times when the tool is switched off and when itis running idle in addition to the trigger time).ENH003-13For European countries onlyEC Declaration of ConformityWe Makita Corporation as the responsiblemanufacturer declare that the following Makitamachine(s):Designation of Machine:Slide Compound Miter SawModel No./ Type: LS1018, LS1018Lare of series production andConforms to the following European Directives:2006/42/ECAnd are manufactured in accordance with the followingstandards or standardised documents:EN61029The technical documentation is kept by our authorisedrepresentative in Europe who is:Makita International Europe Ltd.Michigan Drive, Tongwell,Milton Keynes, Bucks MK15 8JD, England6.11.2009000230Tomoyasu KatoDirectorMakita Corporation3-11-8, Sumiyoshi-cho,Anjo, Aichi, 446-8502, JAPANGEA010-1General Power Tool SafetyWarningsWARNING Read all safety warnings and allinstructions. Failure to follow the warnings andinstructions may result in electric shock, fire and/orserious injury.Save all warnings and instructions forfuture reference. ENB034-6ADDITIONAL SAFETY RULESFOR TOOL1. Wear eye protection.2. Keep hands out of path of saw blade. Avoidcontact with any coasting blade. It can stillcause severe injury.3. Do not operate saw without guards in place.Check blade guard for proper closing beforeeach use. Do not operate saw if blade guarddoes not move freely and close instantly.Never clamp or tie the blade guard into theopen position.4. Do not perform any operation freehand. Theworkpiece must be secured firmly against the turnbase and guide fence with the vise during alloperations. Never use your hand to secure theworkpiece.5. Never reach around saw blade.6. Turn off tool and wait for saw blade to stopbefore moving workpiece or changingsettings.7. Unplug tool before changing blade orservicing.8. Always secure all moving portions beforecarrying the tool.9. Stopper pin which locks the cutter head downis for carrying and storage purposes only andnot for any cutting operations.10. Do not use the tool in the presence offlammable liquids or gases. The electricaloperation of the tool could create an explosion andfire when exposed to flammable liquids or gases.11. Check the blade carefully for cracks ordamage before operation.Replace cracked or damaged bladeimmediately.12. Use only flanges specified for this tool.13. Be careful not to damage the arbor, flanges(especially the installing surface) or bolt.Damage to these parts could result in bladebreakage.14. Make sure that the turn base is properlysecured so it will not move during operation.15. For your safety, remove the chips, smallpieces, etc. from the table top before