Makita LF1000 Instruction Manual

141. High table set up321006043To set up the tool with high table, proceed asfollows.(1) Fall down the tool carefully BACKWARDSwithout fail while holding it with both hands.(2) Turn the hook in the direction of arrow in thefigure to unbundle the feet. Open the tablefeet on one side and push the bottom bar ofthe feet forward fully to be locked by itself.Take the same procedure for the feet on theopposite side. Make sure that the feet at bothsides are completely locked.WARNING:• Make sure that the stopper hooks are perfectlypositioned in the groove of the bracket.(3) Return the tool to the upright position.2. Low table set up1 23006044The feet can be folded as shown in the figure. Tofold down the tool, do as follows.(1) Fall down the tool carefully BACKWARDSwithout fail while holding it with both hands.(2) Pull up first the stopper at the joint of left feettoward yourself to unlock it.(3) Take the same steps for the opposite feet asabove.(4) Use a hook to bundle these feet.(5) Return the tool to the upright position.1. Stopper hook2. Feet3. Hook1. Hook2. Feet3. Stopper hook