Makita HW1300 Instruction Manual

Also see for HW1200: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

9 ENGLISH123► 1. Pressure-resistant water hose 2. Nut of the cou-pling sleeve 3. Coupling sleeveNOTE: If you connect the pressure-resistant waterhose to the faucet using a coupling sleeve, attach it tothe both ends of the hose.2. Connect the pressure-resistant water hose to thefaucet. Apply a suitable itting such as hose band orwater tap joint to secure the hose end with the faucet.1 23► 1. Hose band 2. Water tap joint 3. Pressure-resistant water hoseNOTE: The itting depends on the shape of the faucetto which you connect. Prepare a suitable commercial-ly-bought itting.3. Attach the water hose connector to the inlet (withthe faucet marking) and then insert the coupling sleeve.123► 1. Coupling sleeve 2. Water hose connector 3. InletConnecting/disconnecting thenozzleCAUTION: Always lock the trigger when con-necting/disconnecting the nozzle.Insert the end of the nozzle into the slot on the triggergun and turn it in the direction of the arrow as shown inthe igure. To disconnect, turn the nozzle in the reversedirection while pressing it toward the trigger gun.213► 1. Trigger gun 2. Slot 3. End of the nozzleSome optional nozzles require the connecting joint(optional accessory) to attach to the trigger gun. Attachthe connecting joint to the trigger gun in the same wayas the nozzle.2 31► 1. Nozzle 2. Connecting joint 3. Trigger gunNOTE: The connecting joint is needed when usingthe nozzles included with another model, HW112 orHW121.Connecting the foam nozzleCAUTION: Always lock the trigger when con-necting/disconnecting the nozzle.Prepare a detergent before using the foam nozzle.1. Remove the nozzle from the tank by rotating thenozzle counterclockwise. Attach the nozzle to the trig-ger gun.