Makita HW1300 Instruction Manual

Also see for HW1200: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

8 ENGLISH213► 1. Front half of the handle 2. Rear half of the handle3. High pressure washer body2. Secure the carrying handle with screws(7 pcs).Connecting the high-pressure hoseFor the HW1200 onlyConnect the high-pressure hose to the outlet (with thegun marking). Turn the nut on the high-pressure hoseclockwise while screwing it onto the screw thread of theoutlet.12► 1. Outlet 2. NutCAUTION: Make sure that the high-pressurehose is securely connected. A loose connectionmay blow the high-pressure hose off, resulting in apersonal injury.Attaching the trigger gunConnect the high-pressure hose to the inlet on thetrigger gun. Turn the nut on the high-pressure hoseclockwise while screwing it onto the screw thread onthe inlet.12► 1. Inlet 2. NutCAUTION: Make sure that the high-pressurehose is securely connected. A loose connectionmay blow the high-pressure hose off, resulting in apersonal injury.Connecting to a faucetCAUTION: Always use a pressure-resistantwater hose with ø13 mm or larger diameter andconnect to the faucet using a proper ittings.Otherwise, the water hose and/or the itting maybreak and cause personal injury.NOTICE: Use a pressure-resistant water hoseas short as possible. The amount of intake watershould be higher than the max feed volume of thepump.NOTICE: If you connect to the mains for drink-ing water, use a backlow preventer valve whichmeets the regulations in your region.Prepare a pressure-resistant water hose. Attach thecoupling sleeve to one end and connect the other endto the faucet as follows.1. Remove the nut on the coupling sleeve and passthe pressure-resistant water hose through the nut.Insert the end of the hose into the coupling sleeve andthen tighten the nut.