2SPECIFICATIONSModel DML805LED 20 pcs, 10 WOperating time*(with Battery BL1830) (Approximately) High: 5 hours / Low: 10 hoursPower source 100-240 V 50-60 Hz ACor 14.4 V / 18 V DCStandard battery cartridge BL1415 / BL1415N BL1430 / BL1440 /BL1450BL1815 / BL1815N /BL1820BL1830 / BL1840 /BL1850Voltage (with battery operation) 14.4 V 18 VDimensions (L x W x H) 214 mm x 261 mm x 328 mmNet weight 2.3 kg 2.5 kg 2.4 kg 2.6 kgPressure receiving area (Lens area) 0.0195 m2• Due to our continuing program of research and development, the specifications herein are subject to change without notice.• Specifications and battery cartridge may differ from country to country.• Weight, with battery cartridge, according to EPTA-Procedure 01/2003* This value is only advisory. This may vary according to the condition and environment of the battery.SymbolsThe following show the symbols used for the equipment.Be sure that you understand their meaning before use.• Read instruction manual.• Indoor use onlyCdNi-MHLi-ion• Only for EU countriesDo not dispose of electric equipment orbattery pack together with household wastematerial!In observance of the European Directives,on Waste Electric and Electronic Equipmentand Batteries and Accumulators and WasteBatteries and Accumulators and theirimplementation in accordance with nationallaws, electric equipment and batteries andbattery pack(s) that have reached the endof their life must be collected separately andreturned to an environmentally compatiblerecycling facility.• DOUBLE INSULATION• Optical Radiation (UV and IR).Minimize exposure to eyes or skin.• Do not stare at operating lamp.• Use appropriate shielding or eyesprotection.• Take particular care and attention!IMPORTANT SAFETYINSTRUCTIONSWARNING: When using electric tools, basic safetyprecautions should always be followed to reduce the riskof fire, electric shock, and personal injury, including thefollowing:READ ALL INSTRUCTIONS.CAUTION:1. When the tool is not in use, always switch off, andunplug / remove the battery cartridge from the tool.2. Do not cover or clog the lit tool with cloth or carton,etc. Covering or clogging it may cause a flame.3. Do not use the tool in damp or wet locations. Do notexpose the tool to rain or snow. Do not wash it inwater.4. Do not use the tool in explosive atmospheres, suchas in the presence of flammable liquids, gases ordust.5. Power tool plugs must match the outlet. Never modifythe plug in any way. Do not use any adapter plugswith earthed (grounded) power tools. Unmodifiedplugs and matching outlets will reduce risk of electricshock.6. Avoid body contact with earthed or groundedsurfaces such as pipes, radiators, ranges andrefrigerators. There is an increased risk of electricshock if your body is earthed or grounded.7. Do not abuse the cord. Never use the cord forcarrying, pulling or unplugging the power tool. Keepcord away from heat, oil, sharp edges or movingparts. Damaged or entangled cords increase the riskof electric shock.