Makita DKT360 Instruction Manual

Also see for DKT360: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

8 ENGLISH2. Pour preferred amount of fresh tepid water into thekettle. Then close the lid.CAUTION: Make sure the discharge lockbutton is in locked position. Otherwise boiled watermay be spilled unintentionally and cause burn injury.CAUTION: Do not over fill water exceedingthe maximum line. Otherwise boiled water may beejected and cause burn injury.NOTICE: Prevent no-water burning, do not turnon the appliance without water. Otherwise discolor-ation or malfunction may occur.Fig.63. Put the kettle onto the power supply stand.Fig.74. Push the power switch.The power switch lights up in orange with single beepsound, then boiling starts.1Fig.8► 1. Power switchCAUTION: Do not touch the steam. Risk ofburn injury.Fig.9CAUTION: Do not touch around mark andthe metal part located in the figure during boilingor some time after boiling. Risk of burn injury.1Fig.10► 1. Metal part that may extreme hotNOTE: If you press the power switch right after boil-ing operation, the appliance may not work due to theprotection against high temperature. In this case,allow the appliance to cool and then press the powerswitch again.When the boiling is finished, the appliance turns offautomatically with a few seconds of beep sound.NOTE: When you lift the kettle or the power supplystand while boiling, the appliance stop boiling and thepower switch blinks in orange.— If you return the kettle or the power supply standwhile the power switch is blinking, the appliancerestarts boiling automatically.— Few seconds after you lift the kettle or the powersupply stand, the appliance turns off.NOTE: When the battery capacity becomes lowwhile boiling, the appliance turns off and the powerswitch blinks in red for a few seconds with three beepsounds.NOTE: If you turn on the appliance when at least onebattery capacity is low, the appliance turns off within afew seconds with a single beep sound.