Makita DCS3501 Instruction Manual

Also see for DCS3500: Repair manual Repair manual

Makita DCS3501 Instruction Manual Manual pdf 15 page image

156 82 932 10STOPPull the chain (6) around the sprocket nose (8) of the guidebar in the direction of the arrow.Replace the sprocket guard (3).IMPORTANT:Lift the saw chain over the chain catcher (9).Tighten the nuts (2) only hand-tight to begin with.Tensioning the saw chainTurn the QuickSet chain tensioner (10) to the right (clockwise)using the combination tool, until the saw chain guide elementsengage in the guide groove on the bottom of the guide bar (ifnecessary, pull the chain into position slightly).Raise the tip of the guide bar slightly and turn the chain tensioner(10) further until the saw chain is flush against the bottom of theguide bar (see circle).While still holding up the tip of the guide bar, tighten the retainingnuts (2) with the universal wrench.NOTE: If the guide bar has been turned over, turn the chaintensioner to left (i.e. counter-clockwise) to tighten the chain.Checking the chain tensionThe tension of the chain is correct if the chain rests againstthe bottom side of the guide bar and can still be easily turnedby hand.While doing so the chain brake must be released.Check the chain tension frequently - new chains tend to getlonger during use!When checking the chain tension the engine must be switchedoff.NOTE: It is recommended to use 2-3 chains alternatively.In order to guarantee uniform wear of the guide bar the barshould be turned over whenever replacing the chain.Retensioning the saw chainUse the combination tool to loosen the fastening nuts (2)about one turn. Raise the tip of the guide bar slightly and turnthe QuickSet chain tensioner (10) to the right (clockwise) untilthe saw chain is again flush against the bottom of the guidebar (see circle).While still holding up the tip of the guide bar, tighten the retainingnuts (2) with the universal wrench.