Makita DCS 430 Owner's And Safety Manual

Also see for DCS 431: Spare parts Owner's and safety manual Instruction manual

Contents

Makita DCS 430 Owner's And Safety Manual Manual pdf 21 page image

AVOID SKIN AND EYE CONTACTRefuellingFOLLOW THE SAFETY PRECAUTIONSON PAGE 7!Be careful and cautious when handling fuels.The engine must be switched off1- Thoroughly clean the area around the caps, to prevent dirtfrom getting into the fuel or 08 tank.Unscrewthe cap and fill the tank with fuel (fueVoil mixture)or chain oil as the case may be. Fill up to the bottom edgeof the filler neck. Be careful not to spill fuel or chain oil!Tightly screw on the cap.--Clean screw cap and tank after refuelling.Mineral oil products degrease your skin. If your skin comes incontact with these substances repeatedly and for an extendedperiod of time, it will desiccate. Various skin deseases mayresult. In addition, allergic reactions are known to occur.Eyes can be irritated by contact with oil. If oil comes into youreyes, immediately wash them with clear water.If your eyes are still irritated, see a doctor immediately!Lubricating the chainDuring operation there must always be sufficient chain oil inthe chain-oil tank to provide good chain lubrication. One fillingis sufficient for about one half-hour of continuous operation.Adjusting the chain lubrication WThe engine must be switched off.You can adjust the oil pump feed rate with the adjusting screw(F/l). The adjusting screw is locatedin the housingunderneaththe sprocket guard (F/2). It is accessible from below.The oil pump comes factory-set to a medium feed rate.Note: To set from minimum to maximum oil supply, turnthe adjusting screw (FI1 with adjustment markings) max.a l/4-turn.To ensure troublefree operation of the oil pump the oil guidegroove at the crankcase (W3)and the oil inlet bore in the guidebar (W4) must be cleaned regularly.To change the feed quantity use the universal wrench andadjust the adjusting screw (F/1) in the following way:-- Turn to the right to reduce the feed rate.Tum to the left to increase the feed rate.Note: After the saw has been turned off it is normalfor residualchain oil to drip from the oil feed system, the guide bar and thechain for a time. This doesPlace the saw on a suitable surface.constitute a defect!21