17Approved bar and chain combinations"Low-kickback saw chain is a chain which has met thekickback performance requirements of ANSI B 175.1-1991 (American National Standard for Power Tools-Gasoline-Powered Chain Saws-Safety Requirements)when tested on the representative sample of chainsaws below 3.8. C.l.D. specifed in ANSI B 175.1-1991". The approved bar and chain combinations arelow kickback chains according to ANSI B 175.1-1991and also meet the kickback requirements of CSAZ62.3-96 for chain saws below 80 cm3 .The chain saw DCS 34 has been approved withfollowing guide bar and chain combinations:Drive link gauge .050"Guide bar 3/8" Saw chain 3/8"length Part no. Part no.14" (35 cm) 442 035 661 528 092 65216" (40 cm) 442 040 661 528 092 656"There may be other replacement bar and chain combi-nations available that also reduces the risk of injuryfrom kickback".Technical data DCS 34Single-cylinder two-strokePiston displacement 2.0 cu. in (33 cm3 )Cylinder bore 1.45" (37 mm)Piston stroke 1.22" (31 mm)Max. power at speed 1.3/9,000 kW/rpmMax. torque at speed 1.7/6,500 Nm/rpmIdling speed 2,800 rpmSound Pressure Level at the operator’s earat full load according to ANSI B 175.1 98 db(A)Sound Pressure Level at the bystander’s position(50ft/15 m distance) according to ANSI B 175.1 73 db(A)Ignition systemElectronic, without breakerSpark plug NGK BPMR 7Aor Spark plugElectrode gap .020" (0.5 mm)Fuel systemCarburetor (for Canada) ZAMACarburetor (for USA) ZAMA with limiter caps(all position diaphragm carburetorwith integral fuel pump)Fuel tank capacity 13.0 oz. (0.37 l)Fuel mixture see chapter "Fuel"Weightwithout cutting attachment 10 lbs. 5 oz. (4.7 kg)Cutting attachmentGuide bar sprocket nose barCutting length 14" (35 cm) • 16" (40 cm)Safety saw chain (pitch) 3/8" (528 092 ...)Drive link gauge .050"Chain sprocket 6 teethChain lubrication fully automatic oil pumpOil tank capacity 8.8 oz. (0.25 l)WARNINGDo not use other replacement bars and chainsunless they have been designated as meeting theANSI B 175.1-1991 (for USA) and CSA Z62.3-96(for Canada) kickback performance requirementson that specific powerhead, or has been desig-nated as "low kickback" saw chain in accordancewith the ANSI B 175.1-1991 (for USA) and CSAZ62.3-96 (for Canada) standard.