Makita DCJ205 Instruction Manual

Also see for CJ105D: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

9 ENGLISHPARTS DESCRIPTIONBattery holder (optional accessory)► Fig.11 Battery holder (10.8 V -12 V max)2 Battery holder (14.4 V /18 V)3 Belt hook 4 Strap holeModel CJ105D / DCJ205► Fig.21 Power button 2 Battery pocket 3 Jack 4 Code lockModel CJ106D / DCJ206► Fig.31 Power button 2 Battery pocket 3 Jack 4 Code lock5 Hood 6 Name tag holder - - - -Model CV102D / DCV202► Fig.41 Power button 2 Battery pocket 3 JackINSTALLATIONInstalling or removing the batterycartridgeCAUTION: Always switch off the devicebefore installing or removing the batterycartridge.CAUTION: Hold the battery holder and thebattery cartridge firmly when installing or remov-ing the battery cartridge. Failure to hold the batteryholder and the battery cartridge firmly may causethem to slip out of your hands and result in damageto the battery holder and battery cartridge and/or apersonal injury.► Fig.5: 1. Red indicator 2. Button 3. Battery cartridge4. Battery holder (optional accessory)To install the battery cartridge, align the tongue on thebattery cartridge with the groove in the housing and slipit into place. Insert the battery cartridge all the way untilit locks in place with a small click. If you can see the redindicator on the upper side of the button, it is not lockedcompletely.To remove the battery cartridge, slide it from the batteryholder while pressing the button on the front of thecartridge.CAUTION: Always install the battery car-tridge fully until the red indicator cannot be seen.Otherwise the battery cartridge may accidentallyfall out of the battery holder, causing injury to you orsomeone around you.CAUTION: Do not forcibly install the batterycartridge. If the battery cartridge does not slide ineasily, it is not being inserted correctly.Battery pocketThe battery holder (with battery cartridge) can be storedin the battery pocket. Connect the power cable jackpulled out of the battery pocket to the battery holderplug. Then put the battery holder into the battery pocketand fasten the fastener.► Fig.6: 1. Power cable 2. Jack 3. Plug 4. BatterypocketThe belt hook on the battery holder can be detached byremoving the screws.► Fig.7: 1. Screw 2. Belt hookAttaching the battery holderYou can hang the battery holder on your waist belt.To prevent the battery holder from dropping acciden-tally, attach a strap using the strap hole and secure it.1. Pull the power cable out of the upper hole in thebattery pocket and feed the jack through the lower holein the battery pocket and pull it through to the inside ofthe jacket or vest.► Fig.8: 1. Power cable 2. Upper hole 3. Batterypocket 4. Jack 5. Lower hole2. Attach the belt hook of the battery holder to yourwaist belt, and connect the jack to the battery holderplug.► Fig.9: 1. Belt hook 2. Battery holder 3. Waist belt4. Plug 5. JackThe battery holder has an anti-drop function. Whenremoving the battery holder from the belt, pull up thebattery holder while pressing the unlock button.► Fig.10: 1. Unlock button