Makita CG100D Instruction Manual

Also see for CG100D: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

6 ENGLISHBattery protection systemThe tool is equipped with a battery protection system.This system automatically cuts off power to the motor toextend battery life.The tool will automatically stop during operation if thetool and/or battery are placed under one of the followingconditions:Overloaded:The tool is operated in a manner that causes it to drawan abnormally high current.In this situation, turn the tool off and stop the applicationthat caused the tool to become overloaded. Then turnthe tool on to restart.If the tool does not start, the battery is overheated. Inthis situation, let the battery cool before turning the toolon again.Low battery voltage:The remaining battery capacity is too low and the toolwill not operate. If you turn the tool on, the motor runsagain but stops soon. In this situation, remove andrecharge the battery.Indicating the remaining batterycapacityOnly for battery cartridges with the indicator12Fig.2► 1. Indicator lamps 2. Check buttonPress the check button on the battery cartridge to indi-cate the remaining battery capacity. The indicator lampslight up for a few seconds.Indicator lamps RemainingcapacityLighted Off75% to 100%50% to 75%25% to 50%0% to 25%NOTE: Depending on the conditions of use and theambient temperature, the indication may differ slightlyfrom the actual capacity.Switch actionCAUTION: Before installing the battery car-tridge into the tool, always check to see that theswitch trigger actuates properly and returns tothe "OFF" position when released.CAUTION: When not operating the tool, pushthe trigger-lock button from A side to lock theswitch trigger in the OFF position.A B12Fig.3► 1. Switch trigger 2. Trigger-lock buttonTo prevent the switch trigger from accidentally pulled,the trigger-lock button is provided.To start the tool, depress the trigger-lock button from Aside and pull the switch trigger. Tool speed is increasedby increasing pressure on the switch trigger. Releasethe switch trigger to stop.After use, press in the trigger-lock button from B side.Speed adjusting dial1Fig.4► 1. Speed adjusting dialThe tool speed can be adjusted by turning the speed adjustingdial. You can get the highest speed at 5 and the lowest speed at 1.NOTICE: Do not turn the dial quickly when thetool is working.NOTICE: Depending on the type and conditionsof caulking material, it may not be fed at lowspeed. In this case, set the speed adjusting dialhigher.NOTICE: When changing the speed dial from "5"to "1", turn the dial counterclockwise. Do not turnthe dial clockwise forcibly.