Magnetek Impulse G+ series 4 Instruction Manual

Contents

Magnetek Impulse G+ series 4 Instruction Manual Manual pdf 175 page image

IMPULSE®•G+ & VG+ Series 4 Instruction Manual – February 20175-89F1 and F2 Keys Function SelectionThe F1 and F2 keys on the keypad have the ability of being programmed with specific functions toimitate digital inputs. The table below displays the various settings, which are valid for these buttons.• To operate a function assigned to the F1 or F2 key, the respective button must be held down.Releasing the button will stop the function. Be cautious when operating these keys, andremember that the STOP key will override and stop all functions.• To quickly view the functions assigned to both buttons, press the LO/RE key three times.Table 5-73: F1 and F2 Function Selection Parameter SettingsTable 5-74: F1 and F2 keys function selectable for H01-09 and H01-10Parameter Display Function Range DefaultH01-09 F1 Key Selection Function selection for F1 key 0F–74 0FH01-10 F2 Key Selection Function selection for F2 key 0F–74 0FDisplay Function Instruction Alert/Confirm Message0F Not Used No function -terminal is disabled -- --48 Flt Latch Reset When a fault islatched, toggle thisinput ON and thenOFF to clear thefault.Press F1 or F2 once to pre-start Fault Latch Reset. Aconfirm message will appear,and the same key press willbe required once more toreset a latched fault.Confirm?Flt Latch Reset53 Comm Test Mode Communication TestMode - loopback testof Modbus RS-422/485 interfaceHold down the F1 or F2 keyfor 2–3 seconds to initiate theComm Test.Running:Comm Test Mode5A MaintenanceReset Resets MaintenanceTimer (C12-05, C12-06, U01-52)Press F1 or F2 once to pre-start Maintenance TimerReset. A confirm message willappear, and the same keypress will be required oncemore to reset theMaintenance Timer.Confirm?MaintenanceReset61 Brake Test Motor pushesagainst brake up toprogrammabletorque setting C08-24 at programmablefrequency C08-25.Disabled PG Faultsduring this condition.Hold down the F1 or F2 key toinitiate the Brake Test. Running:Brake Test67 Hook Height Home Used with C03-14 -Height Measurementfunction.Press F1 or F2 once to pre-start Hook Height Home. Aconfirm message will appear,and the same key press willbe required once more tohome the Hook Height.Confirm?Hook Height Home69 LC Bypass N.O. Disables LoadCheck and clearsany LC faults.Hold down the F1 or F2 key toinitiate the LC Bypass. Running:LC Bypass N.O.73 LL2/UL2 Bypass Bypass Limit MFDIand EPLS Hold down the F1/F2 key toinitiate LL2/UL2 Bypass. Running:LL2/UL2 Bypass74 LL/UL Bypass Bypass MFDI andEPLS Hold down the F1/F2 key toinitiate LL/UL Bypass. Running:LL/UL Bypass