5514. Problem solvingPrior to returning the camera for repair check the following list of symptoms andpossible solutions. Please contact our Customer Service if the problem persists.Symptom Cause Possible solutionCamera cannot beswitched on.Battery not or incorrectly inserted. Insert battery correctly.The battery is empty. Charge battery again.The battery charge level dropsquickly.The battery is not fully charged Aftercharging the battery has not been used for alonger period.Fully charge battery and discharge it com-pletely at least once prior to use to increase itsperformance and service life.The battery or camera feelswarm.This can occur when camera/flash are usedfor a longer time. -------------The camera does not take anyphotos despitepressing the shutter release.The shutter release was not pressed fully. Depress shutter release fully.The memory does not have sufficientmemory.Insert a new memory card or delete unwantedfiles.The memory card is write protected. Remove write protection.The LCD display shows noimages. Battery charge level too low. Charge battery again.The camera is set to Autofocus but the focus doesnot work.The lens is dirty. Wipe the lens using a soft, dry cloth or speciallens paper.The distance to the subject matter is greaterthan the effective range.Ensure that the subject matter is within theeffective range.The contents of the memorycard cannot be viewed.You are attempting to view the contents ofa memory card that was not formatted withthis camera.Insert a memory card formatted by the cameraand on which files were saved by the camera.File cannot be deleted. The file is protected. Remove deletion protection.The memory card is write protected. Remove write protection