Lenovo ThinkSystem SR630 Maintenance Manual

Also see for thinksystem SR630: Manual Manual Quick start guide Maintenance manual Product guide

Step 6. Align the pins on the hot-swap rear drive cage with the corresponding hole and slot in the chassis.Then, lower the hot-swap rear drive cage into the chassis until it is fully seated.Figure 81. Hot-swap rear drive cage installationStep 7. Connect the cables to the system board or expansion slots. See “2.5-inch/3.5-inch drive backplane(power)” on page 65 and “2.5-inch/3.5-inch drive backplane (signal)” on page 66.After you finish1. Reinstall the drives or drive fillers into the hot-swap rear drive cage. See “Install a 2.5/3.5-inch hot-swapdrive” on page 125.2. Complete the parts replacement. See “Complete the parts replacement” on page 224.Internal CFF HBA/RAID adapter replacementUse this information to remove and install the internal CFF HBA/RAID adapter.Remove the internal CFF HBA/RAID adapterUse this information to remove the internal CFF HBA/RAID adapter.About this taskAttention:• Read “Installation guidelines” on page 83 to ensure that you work safely.• Power off the server and disconnect all power cords for this task.• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices withan electrostatic-discharge wrist strap or other grounding system.A video for this task is available at:• YouTube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK• Youku: https://list.youku.com/albumlist/show/id_59643656144 ThinkSystem SR630 V2 Maintenance Manual