6. Slide the flex bay storage enclosure into the optical drive bay. See “Device in the optical-drive bay” onpage 102.7. Connect the signal cable and the power cable to the new storage drive.Figure26. Connecting the cables to the storage driveWhat to do next:• To work with another piece of hardware, go to the appropriate section.• To complete the installation or replacement, go to “Completing the parts replacement” on page 189.Device in the 5.25-inch flex moduleAttention: Do not open your computer or attempt any repair before reading and understanding the Chapter1 “Read this first: Important safety information” on page 1.This section provides instructions on how to install or replace a device in the 5.25-inch flex module. Installingand replacing a device in the 5.25-inch flex module involves the following operations:• “Slim optical drive” on page 110• “Card reader” on page 113• “eSATA connector or IEEE 1394 connector” on page 115• “Front Thunderbolt adapter kit” on page 117Slim optical driveTo install or replace a slim optical drive in the flex module, do the following:1. Prepare your computer. See “Preparing your computer and removing the computer cover” on page 99.2. Remove the flex module from the front of the computer. See “Device in the optical-drive bay” onpage 102.110 ThinkStation P510 and P710 Hardware Maintenance Manual
