Lenovo ThinkSmart Hub 500 User Manual And Hardware Maintenance Manual

concealed by an access panel that is secured by more than two screws. You must remove the screwsand panel to access the specific CRU. Optional-service CRUs can be removed and installed by usersor, during the warranty period, by a Lenovo service technician.Before replacing FRUsBefore replacing any FRU, read the following:• Only certified and trained personnel can service the meeting console.• Before replacing an FRU, read the entire section about replacing the part.• Be extremely careful during writing operations such as copying, saving, or formatting.The sequence of the drives in the meeting console that you are servicing might have been altered. If youselect an incorrect drive, data or programs might be overwritten.• Replace an FRU only with another FRU of the correct model.When you replace an FRU, ensure that the model of the machine and the FRU part number are correct.• An FRU should not be replaced because of a single, unreproducible failure.Single failures can occur for a variety of reasons that have nothing to do with a hardware defect, such ascosmic radiation, electrostatic discharge, or software errors. Consider replacing an FRU only when aproblem recurs. If you suspect that an FRU is defective, clear the error log and run the test again. If theerror does not recur, do not replace the FRU.• Only replace a defective FRU.Locating FRUs (including CRUs)Notes:• Self-service CRUs: 10 and 11• Some of the following components are optional.• To replace a component that is not in the list below, contact a Lenovo service technician. For a list ofLenovo Support phone numbers, go to:http://www.lenovo.com/support/phone14 Hub 500 User Guide and Hardware Maintenance Manual