Menu
Lenovo IDEACENTRE 300s series Maintenance Manual
                                                           |
– Send another person to get medical aid.Safety inspection guideThe intent of this inspection guide is to assist you in identifying potentially unsafe conditions on theseproducts. Each machine, as it was designed and built, had required safety items installed to protect usersand service personnel from injury. This guide addresses only those items. However, good judgment shouldbe used to identify potential safety hazards due to attachment of features or options not covered by thisinspection guide.If any unsafe conditions are present, you must determine how serious the apparent hazard could be andwhether you can continue without first correcting the problem.Consider these conditions and the safety hazards they present:• Electrical hazards, especially primary power (primary voltage on the frame can cause serious or fatalelectrical shock).• Explosive hazards, such as a damaged CRT face or bulging capacitor• Mechanical hazards, such as loose or missing hardwareThe guide consists of a series of steps presented in a checklist. Begin the checks with the power off, andthe power cord disconnected.Checklist:1. Check exterior covers for damage (loose, broken, or sharp edges).2. Power-off the computer. Disconnect the power cord.3. Check the power cord for:a. A third-wire ground connector in good condition. Use a meter to measure third-wire groundcontinuity for 0.1 ohm or less between the external ground pin and frame ground.b. The power cord should be the appropriate type as specified in the parts listings.c. Insulation must not be frayed or worn.4. Remove the cover.5. Check for any obvious alterations. Use good judgment as to the safety of any alterations.6. Check inside the unit for any obvious unsafe conditions, such as metal filings, contamination, water orother liquids, or signs of fire or smoke damage.7. Check for worn, frayed, or pinched cables.8. Check that the power-supply cover fasteners (screws or rivets) have not been removed or tampered with.Handling electrostatic discharge-sensitive devicesAny computer part containing transistors or integrated circuits (ICs) should be considered sensitive toelectrostatic discharge (ESD). ESD damage can occur when there is a difference in charge between objects.Protect against ESD damage by equalizing the charge so that the machine, the part, the work mat, and theperson handling the part are all at the same charge.Notes:1. Use product-specific ESD procedures when they exceed the requirements noted here.2. Make sure that the ESD protective devices you use have been certified (ISO 9000) as fully effective.When handling ESD-sensitive parts:• Keep the parts in protective packages until they are inserted into the product.Chapter 2. Safety information 5 |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved