Menu
Lenovo Cisco Catalyst 3012 Product Manual
Also see for Cisco Catalyst 3012: Specifications
               | |
Contents |
This section shows how the Cisco Catalyst Switch Module 3012 can be used in configurations.Basic two-port configurationFigure 2 shows basic use of the Cisco Catalyst Switch Module 3012 to route the two-port Ethernetcontroller that is integrated onto the blade server. Two Ethernet Switch Modules are installed in bay 1 andbay 2 of the BladeCenter chassis. The connections between the controller and the switch modules areinternal to the chassis. No cabling is needed.Figure 2. Using Cisco Catalyst Switch Module 3012 to route the integrated Ethernet portsTable 4 lists the components that are used in the two-port configuration shown in Figure 2.Table 4. Components used in the two-ports-per-server configurationDiagramreferencePart number / machinetypeDescription QuantityVaries BladeCenter HS22 or other server 1 to 14None Ethernet controller on the system board of theserver1 perserverVaries Any BladeCenter server (see Table 2) 143W4395 Cisco Catalyst Switch Module 3012 2Four-port configurationFigure 3 shows the use of four Cisco Catalyst Switch Module 3012 units to route four Ethernet ports fromeach server: the two integrated ports plus two ports supplied by a compatible CFFv or CIOv expansioncard. Four Ethernet Switch Modules are installed in bay 1, bay 2, bay 3, and bay 4 of the BladeCenterchassis. All connections between the controller and card and the switch modules are internal to the chassis.No cabling is needed.Cisco Catalyst Switch Module 3012 for BladeCenter (withdrawn product) 9 |
Related manuals for Lenovo Cisco Catalyst 3012
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved