Menu
Lenovo Cisco Catalyst 3012 Product Manual
Also see for Cisco Catalyst 3012: Specifications
               | |
Contents |
Static IP routing for manually building a routing table of network path information.Equal-cost routing for load-balancing and redundancy.Internet Control Message Protocol (ICMP) and ICMP Router Discovery Protocol (IRDP) for usingrouter advertisement and router solicitation messages to discover the addresses of routers ondirectly-attached subnets.DHCP relay for forwarding UDP broadcasts, including IP address requests, from DHCP clients.IPv6 supportIPv6 host support (IPv6 unicast addressing, IPv6 traffic processing, IPv6 applications supportincluding DNS, ping, traceroute, telnet, ftp, tftp, http, and ssh). IPv6 traffic forwarding is notsupported. IPv6 host support is incorporated into the IP Base software feature set that comesstandard with this switch module.IPv4 and IPv6 coexistence. The switch module supports dual IPv4 and IPv6 protocol stacks toprovide seamless step-by-step migration to an IPv6 environment.Note: Unlike the Cisco Catalyst 3110 family of switches, the Cisco Catalyst 3012 module onlysupports IPv6 host functions, and does not support IPv6 routing (IPv6 traffic forwarding, IPv6 staticroutes, and OSPF, RIP, or EIGRP for IPv6), and IPv6 ACLs.IP unicast reverse path forwarding (unicast RPF) for confirming source packet IP addresses.Monitoring features:Switch LEDs that provide visual port, switch, and stack-level status.SPAN/RSPAN support for local and remote monitoring of the network.Four groups (history, statistics, alarms, and events) of embedded remote monitoring (RMON) agentsfor network monitoring and traffic analysis.MAC address notification for tracking the MAC addresses that the switch has learned or removed.Syslog facility for logging system messages about authentication or authorization errors, resourceissues, and time out events.Layer 2 trace route to identify the physical path that a packet takes from a source device to adestination device.Time Domain Reflector (TDR) to diagnose and resolve cabling problems on 10/100 and 10/100/1000copper Ethernet ports.Online diagnostics to test the hardware functionality of the supervisor engine, modules, and switchwhile the switch is connected to a live network.On-board failure logging (OBFL) to collect information about the switch and the power suppliesconnected to it.Enhanced object tracking (EOT) for HSRP to determine the proportion of hosts in a LAN by trackingthe routing table state or to trigger the standby router failover.Supported IEEE standards:IEEE 802.1d Spanning Tree Protocol (STP)IEEE 802.1s Multiple STP (MSTP)IEEE 802.1w Rapid STP (RSTP)IEEE 802.1p Tagged PacketsIEEE 802.1Q Tagged VLAN (frame tagging on all ports when VLANs are enabled)IEEE 802.1x port-based authenticationIEEE 802.2 Logical Link ControlIEEE 802.3 10BASE-T EthernetIEEE 802.3u 100BASE-TX Fast EthernetCisco Catalyst Switch Module 3012 for BladeCenter (withdrawn product) 6 |
Related manuals for Lenovo Cisco Catalyst 3012
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved