Lenovo 10KY Hardware Maintenance Manual

9. Slide the new optical drive into the drive bay from the front of the computer until the screw hole in thenew optical drive aligns with the corresponding hole in the hard disk drive bracket.Figure13. Installing the optical drive10. Install the screw to secure the optical drive to the hard disk drive bracket.11. Connect the signal cable and the power cable to the new optical drive.Figure14. Connecting the optical driveWhat to do next:• To work with another piece of hardware, go to the appropriate section.• To complete the installation or replacement, go to “Completing the parts replacement” on page 110.Replacing the front bezelAttention: Do not open your computer or attempt any repair before reading and understanding the Chapter1 “Read this first: Important safety information” on page 1.To replace the front bezel, do the following:1. Remove any media from the drives and turn off all connected devices and the computer. Then,disconnect all power cords from electrical outlets and disconnect all cables that are connected to thecomputer.2. Remove the computer cover. See “Removing the computer cover” on page 82.3. Remove the optical drive. See “Replacing the optical drive” on page 82.4. Locate the front bezel. See “Computer components” on page 31.84 Lenovo S510 Hardware Maintenance Manual