• “Replacing the 2.5-inch storage drive (for 10G8, 10G9, 10GA, 10GB, 10GC, 10GD, 10GE, and 10GF)”on page 123• “Replacing the M.2 storage drive” on page 125Replacing the 2.5-inch storage drive (for 10G8, 10G9, 10GA, 10GB, 10GC, 10GD,10GE, and 10GF)To replace the 2.5-inch storage drive, do the following:1. Remove any media from the drives and turn off all connected devices and the computer. Then,disconnect all power cords from electrical outlets and disconnect all cables that are connected to thecomputer.2. Remove the computer cover. See “Removing the computer cover” on page 112.3. If your computer comes with a front Wi-Fi antenna, disconnect the front Wi-Fi antenna cable from theWi-Fi card.4. Remove the screw that secures the storage drive bracket. Slide the storage drive bracket as shown, andthen lift the storage drive bracket to remove it from the computer.Figure54. Removing the storage drive bracket5. Slide the 2.5-inch storage drive as shown, and then lift the 2.5-inch storage drive to remove it from thestorage drive bracket.Figure55. Removing the 2.5-inch storage driveChapter 9. Installing or replacing hardware 123