Larson Electronics HALSS-24-2L-LED-HBL Instruction Manual

Larson Electronics HALSS-24-2L-LED-HBL Instruction Manual Manual pdf 1 page image

HALSS-24-2L-LED-HBLLarson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com 1 of 22' Stainless Steel Hazardous Location LED Light FixtureHeat Treated Glass Lens - Class I, Div. II Instruction ManualThank you for your purchase of the Larson Electronics HALSS-24-2L-LED-HBL.WARNING:READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.CRITICAL SAFETY INSTRUCTIONS:• INSTALLATION SHOULD ONLY BE CONDUCTED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NEC AND ANYRELEVANT LOCAL BUILDING CODES.• RISK OF FIRE OR ELECTRIC SHOCK. FIXTURE INSTALLATION REQUIRES KNOWLEDGE OF FIXTURE'S ELECTRICALSYSTEMS. IF NOT QUALIFIED, CONTACT A QUALIFIED ELECTRICIAN.• BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.• MAKE SURE THE SUPPLY VOLTAGE IS THE SAME AS THE FIXTURE'S RATED VOLTAGE.• TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR SHARPOBJECTS. SUITABLE FOR DAMP LOCATIONS.IMPORTANTREAD CAREFULLY BEFORE INSTALLING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTUREREFERENCE. THE HALSS-24-2L-LED-HBL MUST BE WIREDIN ACCORDANCE WITH NATIONAL ELECTRICAL CODE AND ALL APPLICABLE LOCALCODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.WE STRONGLY ENCOURAGE ONLY A LICENSED ELECTRICIAN INSTALL, OPERATE AND MAINTAIN THISPRODUCT. IF YOU ARE NOT QUALIFIED OR UNFAMILIAR WITH ANY ASPECT OF THIS INSTRUCTIONSHEET, CONSULT AN ELECTRICIAN. THERE ARE NO SERVICEABLE PARTS INSIDE.WARNING: MAKE SURE POWER IS TURNED OFF BEFORE STARTING THEINSTALLATION OR PERFORMING ANY MAINTENANCE.RISK OF FIRE/ELECTRIC SHOCK – DISCONNECT POWER AT BREAKER BEFORE INSTALLING OR SERVICING.RISK OF PERSONAL INJURY – FIXTURE MAY BECOME UNSTABLE OR DAMAGED IF NOT INSTALLED PROPERLY.RISK OF BURN – ALLOW FIXTURE TO COOL BEFORE SERVICING.WARNING:USER SHOULD BE TRAINED IN THE PROPER USE AND MAINTENANCE OF THIS DEVICE. THIS LINECORD IS INTENDED TO ALLOW OPERATORS TO EXTEND POWER TO EQUIPMENT WHEN STATIONARY OUTLETS ARE NOTREADILY AVAILABLE.IMPROPER USE OF THIS CORD, PLUG, AND RECEPTACLE CAN LEAD TO SERIOUS INJURIES OR DEATH TOPERSONNEL.PERIODIC INSPECTION OF THE CORD IS NECESSARY.THE CORD MUST BE ROUTINELY CHECKED FOR CUTS, BREAKS, OR ANY SEVERE ABRASIONS, AND IF ANY ARE FOUND,THE CORD MUST BE REPLACED BEFORE RESUMING USE.The Larson Electronics HALSS-24-2L-LED-HBL Hazardous Area LED Light Fixture is ETL approved Class 1 Division 2Groups A, B, C and D - 1598A listed and is specifically designed to withstand high vibration locations and the rigors of wetand corrosive marine environments.

/ 2

Related manuals for Larson Electronics HALSS-24-2L-LED-HBL